Logic & Motors supplied by ATX or laptop power supply (12-20V 120W minimum) - Logic supplied by USB bus (if enabled by solder jumper) - Logic supplied by on-board voltage regulator - on-board USB connectivity Supports multiple power configurations (Carried from Sanguinololu).Includes X, Y, Z, and fourth endstop called E-Stop to be used as an emergency stop, or extruder stop (to be added in firmware). 2 N-MOSFETs for Extruder and Heatbed control.On-board 4-channel DAC to control stepper set current (Rev F).Four integrated Allegro A4982 Stepper Drivers (no Pololus needed).No FTDI serial-to-USB chip! - 128kb Flash Atmel AT90USB1286 Microcontroller (or AT90USB1287 drop-in compatible for 20mhz support).The AT90USB connects at any baud rate regardless of firmware configuration, and operates virtually free of serial communication errors/pauses. On-chip USB means dramatically faster firmware upload times and communication. The Atmel AT90USB1286 MCU has on-chip USB, removing the need for the FTDI UART (USB-to-serial) IC. Printrboard is a derivative of Teensylu, an AT90USB1286 development board originally based on Sanguinololu. All extra I/O ports of the AT90USB have been broken out to headers for prototyping and expansion. Printrboard also has expansion headers supporting I2C, SPI, UART, and ADC pins. ![]() Printrboard improves upon the previous production-grade electronics set ( Gen6) by adding heatbed and SD card support, reverting to 1/16 microstepping Allegro stepper drivers, and improving connectivity reliability and reducing cost by elimination of the FTDI UART chip. The Printrboard electronic set was designed by members of the Printrbot team in order to eliminate the production and functionality shortcomings of older RepRap electronics sets.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |